Description
1Support 51 STM8S STM32 and other microcontroller development boards. 2The module is nRF24L01P + PA + LNA and its driving method is exactly the same as nRF24L01P. Users can operate according to the nRF24L01P chip manual. 3The CE pin is connected to the LNA enable pin. When CE = 1, the LNA is turned on. When CE = 0, the LNA is turned off. This operation is identical to the transmit and receive modes of the nRF24L01. In other words, the user does not need to care about the operation of the LNA at all. 4The CE can be connected high for a long time, but the module must first be set to the POWER DOWN power-down mode when writing to the register. It is recommended to connect the CE to the IO port of the MCU. The IRQ can be disconnected and the interrupt status can be obtained using the SPI polling mode. However, it is recommended to use an external interrupt from the microcontroller. 5The module's CE pin timing operation can reach the 10us mentioned in the nRF24L01P technical manual, but we recommend changing it to: SPI operation until CE goes high until the transmit interrupt is completed, then keep 1ms high time, then Lower the CE. The purpose is to switch to receive mode immediately after sending the GT-24. If CE = 0, the LNA is turned off, which will adversely affect the receiving sensitivity.Item Type:Wireless ModuleType:Direct Insert/Patch Mounting(Optional)Serial number product name parameter Summary1 model GT-24 2 RF solution nRF24L01P 3 Module size 30.3 x 14.5mm / 1.19 x 0.57in PCB antenna included4 Working frequency 2.4GHz-2.525GHz Adjustable, 1MHz step5 Production Process Lead-free environmentally friendly process Machine stickers, products must be machine-mounted to ensure consistent batch reliability6 Interface mode 1*8*1.27mm/2*4*2.54mm The patch can also be used with the universal board and line.7 Supply voltage DC: 2.0-3.6V Note: Voltages above 3.6V will cause permanent damage to the module.8 Communication level 0.7VCC-3.3V VCC refers to the module supply voltage9 Measured distance 1000m Clear and empty, maximum power, height 2m, 250K air speed10 Transmit power 4 levels adjustable up to 20dBm About 100mW at maximum power11 Air speed 250K-2Mbps Level 3 adjustable (250Kbps, 1Mbps, 2Mbps)12 Shutdown current About 30uA Test conditions: CE=0, power down mode, VCC=3.0V13 Emission current About 90mA Power supply capacity must be greater than 250mA14 Receiving current About 20mA CE=115 Antenna form PCB antenna / ipex carrier antenna 16 Communication Interface SPI High speed power up to 10Mbps17 Launch length Single packet 1-32 bytes 3-level FIFO18 Receiving length Single packet 1-32 bytes 3-level FIFO19 RSSI support not support Only simple packet loss statistics are supported20 Receiving sensitivity -B2294dBm@250Kbp 21 Operating temperature -40~+85C Industrial grade22 Working humidity 10%-90% Relative humidity, no condensation23 Storage temperature -40~+125C --- Air speedShutdown current- Brand: Gegong
- Category: Forestry & Logging
- Fruugo ID: 147077008-310219754
- Sold by: Shenzhen Qimo Network Technology
Comment